由 Julian Bohrer | 10 月 8, 2025
Possible causes: The wiring might be incorrect or the cable could be damaged. The Modbus communication lines (D+ and D−) may be reversed. If you’re using Modbus TCP, the sensor might be connected directly to a PC instead of through a network switch or hub. The...
由 Julian Bohrer | 10 月 8, 2025
Possible causes: The output signal wiring might be connected incorrectly. A fuse or component in the measurement system may be blown. The analog output scaling (e.g., 4–20 mA) might not be correctly configured. The installed output board might not match your system’s...
由 Julian Bohrer | 10 月 8, 2025
Possible causes: The sensor may be incorrectly installed — for example, not centered or installed at the wrong depth. The wrong gas type, flow units, or reference conditions may be selected in the settings. The inner pipe diameter might be entered incorrectly in the...
由 Julian Bohrer | 10 月 8, 2025
Possible causes: The air or gas might be contaminated with moisture, oil, or particles. Turbulent flow caused by nearby elbows, valves, or other obstructions may be affecting readings. The sensor could be loose or not inserted to the correct depth. Solutions: Inspect...
由 Julian Bohrer | 10 月 8, 2025
Possible causes: There might be leaks or bypasses between the sensors. One or more sensors might have incorrect scaling or pipe diameter settings. Some sensors might not be measuring the full flow path due to poor installation locations. Solutions: Check the system...
